Maybe that's a point for Protel to address. Not a bug really, but not very
useful either.
Their board report has gotten better over the years. Probably by suggestion.
Tony
> -----Original Message-----
> From: Steve Smith [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, May 17, 2001 12:39 PM
> To: 'Protel EDA Forum'
> Subject: Re: [PEDA] Board Size - Conflict
>
>
> This report give the overall size from the 0,0 point to the
> most extreme item on your layout (text, notes, targets, etc...).
> Not just to the edges of your board.
>
> In other words, anything from the far lower left to top upper
> right that is placed on the layout.
>
> Its only good for notifying you of things dangling out in never
> never land.
>
> Steve Smith
>
>
> > -----Original Message-----
> > From: Jim Muehlberg [mailto:[EMAIL PROTECTED]]
> > Sent: Thursday, May 17, 2001 3:22 PM
> > To: Protel Forum
> > Subject: [PEDA] Board Size - Conflict
> >
> >
> > My PCB is (or so I thought it was) 10000 X 6500 mils as
> > indicated on the
> > mechanical layer. BUT, when I go to reports|board
> > information-general,
> > is says 10360 x 6785.987 mils.
> >
> > What gives?
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
