> as i mentioned before, one of the boards has 4 power planes and 2
> signal layers, and the other board has 4 signal layers and two power
> planes.
I didn't notice this little bit before and it may make quite a
difference for the board manufacturer. You can make life difficult for
them by having large areas of copper as well as areas of fine
track/gap as would happen on one of your eventual combined
layers. I would suggest you create two asets of gerbers and go visit
the fab shop. They know what is going to work for them and you
know what you want at the end. Even though Camtastic will do
what you need, they will have a similar tool and be proficient at
using it.
Steve.
======================================================
Steve Baldwin Electronic Product Design
TLA Microsystems Ltd Microcontroller Specialists
PO Box 15-680, New Lynn http://www.tla.co.nz
Auckland, New Zealand ph +64 9 820-2221
email: [EMAIL PROTECTED] fax +64 9 820-1929
======================================================
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
