Yes this works, but it assumes that the pin numbers will be
sequential (usually not the case), and then one needs to go back and
edit the pin numbers.
I guess I have developed a habit (perhaps a bad, or a less efficient
one) of creating all of the pins first. This is (was?) my way of
insuring that all the required pins were in a design. I suppose
this could mostly be verified (the correct number of pins and no
duplicates) through the report files though. hmmm.
I still think this would be a useful feature though.
---Phil
LD> Hi Phil,
>>- It would be really nice to be able to assign pinnames in the
>>schematic library (and their electrical type), just like one now does
>>when assigning netnames in Schematic. Define the first one, and then
>>click on the pins, and the names are assigned with an autoincrement,
>> and the same electrical type.
LD> Mine already does....
LD> I'm using 99SE SP6. I've just tested it and I'm able to place a pin
LD> labelled, say:
LD> Pin# = 1; PinName = D0
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
