It also seems that the language selection is over written by the file extension, i.e. *.bas for basic *.asm for assembler etc... -----Original Message----- From: Aalt Lokhorst [mailto:[EMAIL PROTECTED]] Sent: Monday, 2 July 2001 9:59 PM To: Protel EDA Forum Subject: Re: [PEDA] Making Macros, WAS: Simple Improvements Joop Reekers wrote, >However, if I select Tools >> Change Language, I don't get a list of >languages to choose from. >What is wrong, or what am I doing wrong? The wrong process is connected to the 'Tools>> Change Language' menu item. I am not 100% sure but I think it should be the process 'TextEdit:SetupLanguage' It is possible to change it in the same way as you do customization. (The arrow menu top-left) I think there is also the option to change the 'Language' in the left panel if the textfile is 'active'. Aalt Lokhorst (e-mail [EMAIL PROTECTED]) address: Schut Geometrische Meettechniek bv Duinkerkenstraat 21 9723 BN Groningen, The Netherlands tel. +31 50-5877877 fax. +31 50-5877899 * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * - or email - * mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
