Am 18.05.16 um 16:12 schrieb ekoyle+puck.nether.net at gmail.com (Eldon Koyle):
You can run 40G without stacking on the 7750, although you may need to
change some default stacking settings.  What code version are you running?

Hello,
we are running 08040a.

The Brocade manual says:
In release 8.0.30, the breakout support on the 40G interfaces will be supported 
on a standalone mode only. Breakout ports will not be supported with stacking 
configuration.
http://www.brocade.com/content/html/en/feature-guide/brocade-icx7750-breakout-ports-fg/GUID-459FAE8C-4013-4E6C-9AE9-BEE4977BA22C.html

But this was just a side note as we did not expect such a limitation and were suprised when we discovered that information in the manual.


I suspect support for third-party breakout cables is very limited.

Is there any difference on the switch side if there is a breakout cacble connected? Is there such a thing like hardware support for breakout cables?

Until now, I was under the impression that a 40G port is just an aggregated 4x10G port and the switch just needs to deactivate the aggregation in order to break out? Am I wrong?



Best regards,

Franz Georg Köhler



_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp

Reply via email to