On May 19, 2016 7:45 AM, "Franz Georg Köhler" <[email protected]> wrote: > > Am 18.05.16 um 16:12 schrieb ekoyle+puck.nether.net at gmail.com (Eldon Koyle): > >> You can run 40G without stacking on the 7750, although you may need to >> change some default stacking settings. What code version are you running? > > > Hello, > we are running 08040a. > > The Brocade manual says: >> >> In release 8.0.30, the breakout support on the 40G interfaces will be supported on a standalone mode only. Breakout ports will not be supported with stacking configuration. > > http://www.brocade.com/content/html/en/feature-guide/brocade-icx7750-breakout-ports-fg/GUID-459FAE8C-4013-4E6C-9AE9-BEE4977BA22C.html > > But this was just a side note as we did not expect such a limitation and were suprised when we discovered that information in the manual. >
So you wanted to create a stack over a breakout cable? I suspect there are some hardware or software limitations that make that difficult for brocade to implement. > > >> I suspect support for third-party breakout cables is very limited. > > > Is there any difference on the switch side if there is a breakout cacble connected? Is there such a thing like hardware support for breakout cables? > > Until now, I was under the impression that a 40G port is just an aggregated 4x10G port and the switch just needs to deactivate the aggregation in order to break out? Am I wrong? > > Although at the physical layer a 40G port is 4 10G channels, there may be some shared resources for the port that don't act separately, so the PHY and the software both need to support breakout cables. One other thing to note, I have found support for 3rd party twinax cables to be abysmal (it will try to use them, but there may be issues where a port shows up even though the remote end is disabled; also high error rates). -- Eldon
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
