Hi Scott, The 35 pins on a 1635 splicer are always up, but from your photos, someone physically yanked them out of your splicer. The buttons are for raising and lowering the 16 pins. -Sorry for the bad news, ---Buck
Lawrence 'Buck' Bito Movette Film Transfer 1407 Valencia St, San Francisco, CA 94110 Open Tuesday through Saturday: Tues. and Thurs.: 8-6 Wed. and Fri.: 9-6 Saturday: 10-4 www.movettefilm.com On Feb 8, 2015 1:40 PM, Scott Stark <[email protected]> wrote: Thankd Jeff, will try that. Any idea on how to align the two film strips without the pins? The 16mm seems to be the only one on the right; there are two other holes on the left that might produce pins once it's unglued. Or are 35mm pros so expert they don't need pins? thanks Scott At 03:00 PM 2/8/2015, you wrote: >On this older version, I think the front and >back buttons work in tandem push on the rear >one to move pins in one direction, the front to >move in the other. Same on each side. >The pins may be stuck try some acetone in the >holes around the pins to dissolve old film >cement. Work the buttons back and forth. >Good luck! > >Jeff Kreines > > > On Feb 8, 2015, at 2:33 PM, Scott Stark <[email protected]> wrote: > > > > Hi all, I have a Bell & Howell 35mm/16mm hot > splicer that supposedly has "retractable" 16mm > registration pins. I'm wanting to cut some 35mm neg on it. > > > > Does anyone know how to retract the pins? And > how to align the 35mm film without them? I > don't see any other pins other than the 16mm > ones right in the middle of the 35mm image. > There are some buttons on the sides that don't > seem to move, and some other nuts and screws. > > > > Pics: > > > > http://hi-beam.net/temp/IMG_1597.JPG > > http://hi-beam.net/temp/IMG_1596.JPG > > > > I have seen this splicer mentioned here: > http://www.smecc.org/film_cameras_for_television_news.htm > but could not find a manual for it. > > > > Thanks for any advice! > > > > best, > > Scott > > www.scottstark.com > > www.hi-beam.net > > > > > > _______________________________________________ > > FrameWorks mailing list > > [email protected] > > https://mailman-mail5.webfaction.com/listinfo/frameworks > >Jeff Kreines >Kinetta >[email protected] >kinetta.com > > >_______________________________________________ >FrameWorks mailing list >[email protected] >https://mailman-mail5.webfaction.com/listinfo/frameworks _______________________________________________ FrameWorks mailing list [email protected] https://mailman-mail5.webfaction.com/listinfo/frameworks
_______________________________________________ FrameWorks mailing list [email protected] https://mailman-mail5.webfaction.com/listinfo/frameworks
