Getting back to your question of a manual for your splicer - in case you manage to get one with 35 pins. The B&H splicers were reproduced by Maier-Hancock and the operation is unchanged. Whatever angel runs apecity has warehoused tons of manuals including the Maier-Hancock 1635/816 manual. Here's the index of available manuals:
http://www.apecity.com/manuals/ and a direct link to the Maier-Hancock manual: http://www.apecity.com/manuals/pdf/maier-hancock_portable_hot_splicer_instructions.pdf -Good luck! ---Buck Lawrence 'Buck' Bito Movette Film Transfer 1407 Valencia St, San Francisco, CA 94110 Open Tuesday through Saturday: Tues. and Thurs.: 8-6 Wed. and Fri.: 9-6 Saturday: 10-4 www.movettefilm.com On Feb 8, 2015 12:34 PM, Scott Stark <[email protected]> wrote: Hi all, I have a Bell & Howell 35mm/16mm hot splicer that supposedly has "retractable" 16mm registration pins. I'm wanting to cut some 35mm neg on it. Does anyone know how to retract the pins? And how to align the 35mm film without them? I don't see any other pins other than the 16mm ones right in the middle of the 35mm image. There are some buttons on the sides that don't seem to move, and some other nuts and screws. Pics: http://hi-beam.net/temp/IMG_1597.JPG http://hi-beam.net/temp/IMG_1596.JPG I have seen this splicer mentioned here: http://www.smecc.org/film_cameras_for_television_news.htm but could not find a manual for it. Thanks for any advice! best, Scott www.scottstark.com www.hi-beam.net _______________________________________________ FrameWorks mailing list [email protected] https://mailman-mail5.webfaction.com/listinfo/frameworks
_______________________________________________ FrameWorks mailing list [email protected] https://mailman-mail5.webfaction.com/listinfo/frameworks
