On Fri, 2016-03-25 at 23:33 +0300, Ruslan Makhmatkhanov wrote: > Hello, > > I have this in pciconf output: > > ===================================================================== > = > none1@pci0:36:0:0: class=0x088000 card=0x167e103c > chip=0x2392197b > rev=0x30 hdr=0x00 > vendor = 'JMicron Technology Corp.' > device = 'SD/MMC Host Controller' > class = base peripheral > > none2@pci0:36:0:3: class=0x088000 card=0x167e103c > chip=0x2393197b > rev=0x30 hdr=0x00 > vendor = 'JMicron Technology Corp.' > device = 'MS Host Controller' > class = base peripheral > ===================================================================== > = > > And my SD-card controller is not working anymore (it worked on > -current > on the same laptop year or two ago). Do I need to load some kld to > make > it working, or support for this controllers was dropped altogether > for > some reason? I have mostly vanilla GENERIC at r296772, but it > actually > stopped to work much earlier. > > Thanks. >
Do you have a pciconf entry for class=080501 chip=0x2391197b, device would probably be "SD Host Controller", and if so, is it none@pci or sdhci_pci@pci ? If sdhci_pci attached, there would be dmesg output for it, and I'm curious whether any irq-related error showed up when it attached. The only change I can find that might have some effect is a switch to MSI-based interrupts some time ago. That was MFC'd to 10-stable in r271051, and that's very close to range cited in that PR. It might be worth trying to set hw.sdhci.enable_msi=0 in loader.conf and see if it makes a difference. -- Ian _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "[email protected]"
