It seems John Baldwin wrote:
> Can you post a dmesg of your box?

Sure, attached the dmesg from the system that is worst affected:

Copyright (c) 1992-2001 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #6: Thu Jan 18 21:39:51 CET 2001
    [EMAIL PROTECTED]:/u1/src/sys/compile/TEST
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (910.36-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x683  Stepping = 3
real memory  = 536850432 (524268K bytes)
avail memory = 518602752 (506448K bytes)
Changing APIC ID for IO APIC #1 from 3 to 1 in MP table
Changing APIC ID for IO APIC #1 from 3 to 1 on chip
Programming 16 pins in IOAPIC #0
IOAPIC #0 intpin 2 -> irq 0
Programming 16 pins in IOAPIC #1
IOAPIC #1 intpin 0 -> irq 5
IOAPIC #1 intpin 1 -> irq 6
IOAPIC #1 intpin 4 -> irq 2
IOAPIC #1 intpin 8 -> irq 11
IOAPIC #1 intpin 9 -> irq 12
IOAPIC #1 intpin 14 -> irq 10
FreeBSD/SMP: Multiprocessor motherboard
 cpu0 (BSP): apic id:  3, version: 0x00040011, at 0xfee00000
 cpu1 (AP):  apic id:  0, version: 0x00040011, at 0xfee00000
 io0 (APIC): apic id:  2, version: 0x000f0011, at 0xfec00000
 io1 (APIC): apic id:  1, version: 0x000f0011, at 0xfec01000
Preloaded elf kernel "kernel" at 0xc03f3000.
Preloaded elf module "random.ko" at 0xc03f309c.
Pentium Pro MTRR support enabled
Using $PIR table, 11 entries at 0xc00f0cb0
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <ServerWorks NB6635 3.0LE host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0xd800-0xd83f mem 
0xfd800000-0xfd8fffff,0xfe000000-0xfe000fff irq 2 at device 2.0 on pci0
fxp0: Ethernet address 00:e0:18:00:c8:15
atapci0: <HighPoint HPT370 ATA100 controller> port 
0xb000-0xb0ff,0xb400-0xb403,0xb800-0xb807,0xd000-0xd003,0xd400-0xd407 irq 5 at device 
3.0 on pci0
ata2: at 0xd400 on atapci0
ata3: at 0xb800 on atapci0
atapci1: <HighPoint HPT370 ATA100 controller> port 
0x9400-0x94ff,0x9800-0x9803,0xa000-0xa007,0xa400-0xa403,0xa800-0xa807 irq 6 at device 
4.0 on pci0
ata4: at 0xa800 on atapci1
ata5: at 0xa000 on atapci1
pci0: <display, VGA> at 7.0 (no driver attached)
isab0: <PCI-ISA bridge> at device 15.0 on pci0
isa0: <ISA bus> on isab0
atapci2: <ServerWorks ROSB4 ATA33 controller> port 0x8800-0x880f at device 15.1 on pci0
ata0: at 0x1f0 irq 14 on atapci2
ata1: at 0x170 irq 15 on atapci2
ohci0: <OHCI (generic) USB controller> mem 0xfb000000-0xfb000fff irq 10 at device 15.2 
on pci0
usb0: OHCI version 1.0, legacy support
usb0: <OHCI (generic) USB controller> on ohci0
usb0: USB revision 1.0
uhub0: (unknown) OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 4 ports with 4 removable, self powered
pcib1: <ServerWorks NB6635 3.0LE host to PCI bridge> at pcibus 1 on motherboard
pci1: <PCI bus> on pcib1
pci1: <mass storage, SCSI> at 5.0 (no driver attached)
pci1: <mass storage, SCSI> at 5.1 (no driver attached)
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
unknown: <PNP0401> can't assign resources
unknown: <PNP0501> can't assign resources
unknown: <PNP0501> can't assign resources
unknown: <PNP0303> can't assign resources
APIC_IO: Testing 8254 interrupt delivery
APIC_IO: Broken MP table detected: 8254 is not connected to IOAPIC #0 intpin 2
APIC_IO: routing 8254 via 8259 and IOAPIC #0 intpin 0
ad0: 8063MB <IBM-DTTA-350840> [16383/16/63] at ata0-master UDMA33
ar0: 146617MB <ATA RAID0 array> [18691/255/63] subdisks:
  ad4: 73308MB <IBM-DTLA-307075> [148945/16/63] at ata2-master UDMA100
  ad6: 73308MB <IBM-DTLA-307075> [148945/16/63] at ata3-master UDMA100
ar1: 146617MB <ATA RAID0 array> [18691/255/63] subdisks:
  ad10: 73308MB <IBM-DTLA-307075> [148945/16/63] at ata5-master UDMA100
  ad8: 73308MB <IBM-DTLA-307075> [148945/16/63] at ata4-master UDMA100
acd0: DVD-RAM <HITACHI GF-1000 B> at ata0-slave using PIO4
acd1: CD-RW <RICOH CD-R/RW MP7040A> at ata1-slave using PIO4
Mounting root from ufs:/dev/ad0a
SMP: AP CPU #1 Launched!


To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message

Reply via email to