On Tue, 27 Aug 2002, Mitsuru IWASAKI wrote:

> Hi,
> Could you put the following lines into /boot/loader.conf and send
> dmesg output again?
> ----
> debug.acpi.layer="ACPI_ALL_COMPONENTS"
> debug.acpi.level="ACPI_LV_ERROR"
> ----

   Of course, here we go :)

> >    [sent privately to not spam the lists with my dump files]
> > 
> > On Mon, 26 Aug 2002, Mitsuru IWASAKI wrote:
> > 
> > > >    FYI, I have now a "can't fetch resources for \\_SB_.PCI0.FNC0.PRT_ -
> > > >    AE_BAD_DATA" with acpica-unix-20020815 during boot.
> > > 
> > > I'd like to make sure if AE_BAD_DATA error occurred w/ previous
> > > versions (acpica-unix-20020725, 20020611, 20020404...) ?
> > > Or first time w/ acpica-unix-20020815 ?
> > 
> >    This error did not happened with previous versions of acpi
> Hmmm...  OK, I put your full ASL at:

   Thanks a lot. I must apologize though, I had the same error with
   previous versions of acpi (I should have checked, sorry, I confounded
   2 laptops)


   - yann
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #29: Tue Aug 27 21:35:25 CEST 2002
    [EMAIL PROTECTED]:/usr/obj/usr/src/sys/TAZ
Preloaded elf kernel "/boot/kernel/kernel" at 0xc06a7000.
Preloaded elf module "/boot/kernel/usb.ko" at 0xc06a70a8.
Preloaded elf module "/boot/kernel/ums.ko" at 0xc06a7150.
Preloaded elf module "/boot/kernel/vga_pci.ko" at 0xc06a71f8.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc06a72a4.
ACPI debug layer 0xfff  debug level 0x8
Timecounter "i8254"  frequency 1193182 Hz
Timecounter "TSC"  frequency 847427840 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (847.43-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x686  Stepping = 6
real memory  = 267780096 (261504K bytes)
avail memory = 252694528 (246772K bytes)
Pentium Pro MTRR support enabled
netsmb_dev: loaded
Using $PIR table, 9 entries at 0xc00f0300
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <TOSHIB 750     > on motherboard
acpi0: power button is handled as a fixed feature programming model.
Timecounter "ACPI-fast"  frequency 3579545 Hz
acpi_cpu0: <CPU> on acpi0
acpi_tz0: <thermal zone> on acpi0
pcib1: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib1
pcib2: <ACPI PCI-PCI bridge> at device 1.0 on pci0
pci1: <ACPI PCI bus> on pcib2
vga_pci0: <Generic PCI VGA> mem 
 irq 11 at device 0.0 on pci1
pcib3: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci2: <ACPI PCI bus> on pcib3
pcm0: <Yamaha DS-1E (YMF754)> port 0xdf3c-0xdf3f,0xdf40-0xdf7f mem 
0xf7df8000-0xf7dfffff irq 11 at device 7.0 on pci2
fxp0: <Intel Pro/100 Ethernet> port 0xdec0-0xdeff mem 0xf7df7000-0xf7df7fff irq 11 at 
device 8.0 on pci2
fxp0: Ethernet address 00:00:39:ee:60:38
inphy0: <i82562ET 10/100 media interface> on miibus0
inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
pcib3: device is routed to IRQ 11
pcic0: <TI PCI-1410 PCI-CardBus Bridge> irq 11 at device 12.0 on pci2
pcic0: PCI Memory allocated: 0xf7d00000
pcic0: TI12XX PCI Config Reg: [pwr save][pci only]
pccard0: <PC Card 16-bit bus (classic)> on pcic0
pcic1: <Toshiba ToPIC95B PCI-CardBus Bridge> irq 11 at device 13.0 on pci2
pcic1: PCI Memory allocated: 0xf7d01000
pccard1: <PC Card 16-bit bus (classic)> on pcic1
pcic2: <Toshiba ToPIC95B PCI-CardBus Bridge> irq 11 at device 13.1 on pci2
pcic2: PCI Memory allocated: 0xf7d02000
pccard2: <PC Card 16-bit bus (classic)> on pcic2
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH2 ATA100 controller> port 0xcff0-0xcfff at device 31.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> port 0xcf80-0xcf9f irq 11 at 
device 31.2 on pci0
usb0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
ums0: Logitech USB-PS/2 Optical Mouse, rev 2.00/11.00, addr 2, iclass 3/1
ums0: 3 buttons and Z dir.
uhci1: <Intel 82801BA/BAM (ICH2) USB controller USB-B> port 0xcf60-0xcf7f irq 11 at 
device 31.4 on pci0
usb1: <Intel 82801BA/BAM (ICH2) USB controller USB-B> on uhci1
usb1: USB revision 1.0
uhub1: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
pci0: <simple comms> at device 31.6 (no driver attached)
atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model IntelliMouse, device ID 3
fdc0: <enhanced floppy controller (i82077, NE72065 or clone)> port 0x3f7,0x3f0-0x3f5 
irq 6 drq 2 on acpi0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
sio0 port 0x3f8-0x3ff irq 4 on acpi0
sio0: type 16550A
   rsirq-0234 [15] RsIrqResource         : Invalid interrupt polarity/trigger in 
resource list
can't fetch resources for \\_SB_.PCI0.FNC0.PRT_ - AE_BAD_DATA
ppc0: parallel port not found.
acpi_lid0: <Control Method Lid Switch> on acpi0
acpi_cmbat0: <Control method Battery> on acpi0
acpi_cmbat1: <Control method Battery> on acpi0
acpi_acad0: <AC adapter> on acpi0
acpi_timer0: <24-bit timer at 3.579545MHz> port 0xee08-0xee0b on acpi0
ppc0: parallel port not found.
ppc0: parallel port not found.
orm0: <Option ROMs> at iomem 0xe0000-0xeffff,0xc0000-0xcbfff on isa0
pmtimer0 on isa0
ppc0: parallel port not found.
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounters tick every 1.000 msec
Initializing GEOMetry subsystem
DUMMYNET initialized (011031)
ipfw2 initialized, divert enabled, rule-based forwarding enabled, default to accept, 
logging limited to 100 packets/entry by default
IP Filter: v3.4.28 initialized.  Default = pass all, Logging = enabled
pccard: card inserted, slot 0
ata1-slave: timeout waiting for interrupt
ata1-slave: ATAPI identify failed
ad0: 19077MB <TOSHIBA MK2016GAP> [38760/16/63] at ata0-master UDMA66
acd0: DVD-ROM <TOSHIBA DVD-ROM SD-C2402> at ata1-master PIO4
Mounting root from ufs:/dev/ad0s2a
Kerneldump off=3276274688 len=515948544
wi0 at port 0x240-0x27f irq 11 slot 0 on pccard0
wi0: 802.11 address: 00:02:2d:13:0a:00
wi0: using Lucent Embedded WaveLAN/IEEE
wi0: Lucent Firmware: Station 6.14.01
/dev/vmmon: Module vmmon: registered with major=200 minor=0 tag=$Name: build-570 $
/dev/vmmon: Module vmmon: initialized

Reply via email to