Geoff, What format is your data source for this job? Are you using a flat file, or an ODBC connection?
I encountered the same problem with 4.0 imposition when trying to use ODBC along with stack settings. My fix was to export the data from my database to a flat file, and then imposition with stack worked fine. I have been told that Printable is aware of the ODBC / stack problem, and is working on a fix. Let me know if this applies to your situation, or you want any more information. - Paul Paul Klingler IT Project Coordinator VDP TMR, Inc. [EMAIL PROTECTED] > I have had no problems > creating templates to correctly impose for cut & stack postcard runs on my > iGen until I recently upgraded from 3.2 to 4.1. When I edit the template > the numbers correctly display by record number based on my stack count > entered, but when the job composes it simply prints recs 1-8, 8-16 etc per > sheet for an 8-up 4X2 run. I'm at a critical point here with my > management and need some help immediately. > Thanks in advance, > Geoff -- Users of FusionPro Desktop have unlimited free email support. Contact Printable Support at [EMAIL PROTECTED] -- View FusionPro Knowledge Base, FusionPro Samples at www.printable.com/vdp/desktop.htm -- You are currently subscribed to fusionpro as: [email protected] To unsubscribe send a blank email to [EMAIL PROTECTED] -- -- Note: All e-mail sent to or from this address will be received or otherwise recorded by the e-mail recipients of this forum. It is subject to archival, monitoring or review by, and/or disclosure to someone other than the recipient. Our privacy policy is posted on www.printplanet.com --
