Hi Peter & all; It's me again! The 2 ATA cables in my MT both have 3 connectors, but different part numbers. The numbers are as follows: Foxconn #=080-0003-192 with 3 connectors Foxconn #=080-0004-192 with 3 connectors The 0003# cable is hooked to the MOBO @ J9, to the CD at the middle connector with the end connector free. The 0004# cable is laced as per instructions, but not hooked to anything, leaving J10 on the MOBO empty and 2 ends tucked in the drive bay area. The MOBO connector end is tucked behind the PSU. What, if anything, is the difference between the 2 cables? According to sources <grin>, J9 must be used if only 1 ATA bus is used. So I assume that J9 must power the boot drive with J10 powering the CD if both busses are used. Is this correct? This ATTO/Apple SCSI card I have in this MT, is it Ultra Wide SCSI? It has a 68 pin external connector and looks like a 50 pin internal connector. TIA for all the help. --Thanks; Rev. George --Maranatha (means the Lord cometh)
-- G-List is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- We have Apple Refurbished Monitors in stock! | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> G-List list info: <http://lowendmac.com/lists/g-list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/g-list%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
