I have a Beige Tower that I am having a slight "problem" with. I just replaced the Logic Board, then lost my CD-ROM. I did some surfing around to try to figure out why, since it happened in my DT too, and decided to just set the hard disk to "master" and the CD-ROM to "slave". All right so far. I power it up and open firmware displays "can't OPEN:" 30 times then boots normally. I performed the same modification to my Beige desktop running 10.2.8 with no error message. In fact, it seems that switching to master/slave on my G3/500 increased boot speed, while on my underclocked tower I get the open firmware message, followed by normal booting into os 9.1 (get the "bomb" system error if I go to 9.2. Something with audio) Any ideas? It's nothing more than a minor annoyance, since I just installed the board today and have intentions of just using it for my music library. The original had a SCSI card in it. Now, I have a drive from a PC in it.
Bryan -- G-List is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- We have Apple Refurbished Monitors in stock! | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> G-List list info: <http://lowendmac.com/lists/g-list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/g-list%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
