In v18 sip is still present but deprecated - after this its removed.
There is a conversion script (sip->pjsip) for migration. It required a
few sacrificial chickens and much swearing until I got the upstream
trunk to register (iinet in AU). Its all working good now, the pjsip
config is more programmer friendly but also allows much more complex
(read hard to follow/fault find) configuration.
Note that the CLI commands are not equivalent to sip (including help,
its now pjsip) with a different format. After install, but before
re-configuration everything sip related disappears on restart.
BillK
On 3/2/24 09:42, John Covici wrote:
On Fri, 02 Feb 2024 19:29:24 -0500,
Thelma wrote:
When did they implement switch-over from sip to pjsip?
I'm using AudioCode boxes.
I emerged and tried to load asterisk ver.18 but the audiocode would not
register. I suppose ver.16 is the end of the line for me.
On 2/2/24 16:39, William Kenworthy wrote:
Yes, was caught out recently by the replacement of sip with pjsip - currently
on v21.0.2 and working (sip only, simple home setup) Also had some weird
problems with two versions installed (so asterisk started on old working
version even though new one was installed - once I ran depclean it failed due
to the sip/pjsip issue.
BillK
On 2/2/24 23:26, Thelma wrote:
Anybody on the list using Asterisk?
I need some help.
Have save version of asterisk is working correctly on one computer but the
other.
I would use at least asterisk 18 in all cases and if you can later
versions. pjsip has been the preferred version for a while, sip is
still OK, however.
