>----Messaggio originale---- >Da: e...@iol.it >Data: 30/10/2014 9.44 > >What is a RFE for now the possibility to select "by hand", so with many >clicks, different tracks at the same time, on different layers (with some key >modifiers like SHIFT or CTRL as you want). I will try the git sources of today.
I downloaded git sources and easily compiled on my Linux 64 bit host. The only think not included in instructions at: http://gerbv.geda-project.org/ was: sudo apt-get install autopoint sudo apt-get install libtool The binary in '~/c/gerbv/src' directory start correctly. The 'sudo make install' run in '~/c/gerbv/' ended without error, binary was put in: /usr/local/bin/gerbv but runnig 'gerbv' from my home give: efa@ts102757:~$ gerbv gerbv: error while loading shared libraries: libgerbv.so.1: cannot open shared object file: No such file or directory [Exit 127] Anyway as work around, running from build directory work. As you say, multi-layer selection work with Fast and Fast+XOR Rendering mode only. In Normal Rendering, status bar report the incremented number of selection of objects, but no selection can be seen in drawing area This is satisfying for me as now. Now I will try to generate the binary for Win32 But I had other two RFEs: - switching a layer visibility, remove all tracks selections. This undermines the usefulness of cross-layer tracks selection. Normally you need to switch off all other tracks in a full PCB to avoid confusion. - there is no possibility to unselect a single object (keeping shift pressed), like happen in many other vectorial drawing tools. This is needed for example when you select something by mistake Thank you for this good work Valerio ------------------------------------------------------------------------------ _______________________________________________ Gerbv-devel mailing list Gerbv-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/gerbv-devel
