----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
John Robert Weber Inc in Fresno Cal has all the parts you need and they seem to have reasonable prices. Send them a E-Mail at [EMAIL PROTECTED] and they will send you a parts sheet with prices. Or you can send me your E-Mail address and I will scan you a copy of mine. Dick [EMAIL PROTECTED] ----- Original Message ----- From: Jon Page Sent: Tuesday, October 15, 2002 9:30 PM To: John; [email protected] Subject: Re: [COUPERS-FLYIN] Oil Overheating problem ----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]---- John I'm glad you found what the problem was. Basically it shouldn't be very expensive to regrind the crank, install new bearings and a set of rings. At that point you could check the valve guides and lap in the valves and your on the road again. Being on the Canadian Owners Maitenance plan I figure if I did the job myself, I could most likely do the whole thing for under $500. This does not apply to the U.S. unfortunately. Still you should be able to get it done for a max of $1500. Don't let them get carried away! These are very basic simple engines. Check Trade-a-Plane for bearings etc. and you'll see the parts are quite cheap. Good luck and let us know how it works out and at what cost, if you don't mind. Jon Page FLAK MAGNET. ================================================================== TO UNSUBSCRIBE go to: http://ercoupers.com/lists.htm ====================== TO UNSUBSCRIBE go to: http://ercoupers.com/lists.htm
<<attachment: winmail.dat>>
