Yes, but note this will only work if in-between the release of the gOS Patricia is using there actually has been a driver written for her scanner, if that is not the case (which is quite likely, as gOS 3 is quite new) it won't help a bit to do that.
On 8 nov, 19:49, Darth Chaos <[EMAIL PROTECTED]> wrote: > It's possible you may need to install an updated version of the SANE > backend from source. I had to do that in order to get my Canon scanner > properly working on gOS Rocket E. > > On Nov 6, 2:16 am, "[EMAIL PROTECTED]" <[EMAIL PROTECTED]> > wrote: > > > Dear All, > > > I have just installed the GOS Version 3 on my computer; my HP Laserjet > > printer was immediately recognised and is working...however, although > > my Lexmark 2500 scanner shows up on the screen under 'printers', when > > I try to use it by opening the GOS scanning programme (xzane?) the > > programme looks for the scanner and then says no devices found. > > > I am not sure if there is a simple way to address this as I am new to > > GOS (perhaps there is another scanning programme on GOS I am unaware > > of?). I have the driver and software for the scanner on CD but if I > > try to load it is tells me as I have a USB connection this will be > > automatically installed and thus I cannot proceed further than this > > point on the installation CD. > > > I would really appreciate any assistance as I am currently in a very > > remote location with limited internet access to research this further. > > > Thanks in advance > > > Patricia --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "gOS Linux" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [EMAIL PROTECTED] For more options, visit this group at http://groups.google.com/group/goslinux?hl=en -~----------~----~----~----~------~----~------~--~---
