Hi Anthony, How would I test the switch?
Thanks, Bobby -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Anthony Q. Martin Sent: Saturday, February 12, 2011 2:22 PM To: [email protected] Subject: Re: [H] Hooked up everything, PC won't start or just check the power switch connector (from the front of the case) to ensure it is on and has the right polarity... On 2/12/2011 2:21 PM, [email protected] wrote: > Try bypassing the power switch on the case and just short it with a screwdriver to see if it triggers power. Always test the board outside of the case to see if it powers up in case of a grounding issue. > Sent via BlackBerry by AT&T > > -----Original Message----- > From: "Bobby Heid"<[email protected]> > Sender: [email protected] > Date: Sat, 12 Feb 2011 14:19:56 > To:<[email protected]> > Reply-To: [email protected] > Subject: [H] Hooked up everything, PC won't start > > Hey, > > > > I took my daughter's old m/b , cpu, psu, ram and all and was putting it into > another case to make a low powered server. > > I have everything hooked up (I believe). The m/b power light glows, but > when I press the power button, nothing happens. No fans spin up or > anything. > > > > Before I take it all apart to try again, does anyone have any suggestions on > what I could check or try? > > > > BTW, I had asked earlier about putting on Windows Server 2008 R2. Turns out > I can't since this is a 32-bit P4. 2008 R2 is only 64-bit. > > > > Thanks, > > Bobby >
