Have you tried it with a different modem/router? A few years ago I had some
adventures in cheap low-end router hell, and one thing I found was that some
routers had some serious issues, such as Belkin for example. Cisco tested
the best, Linksys was second. Most others had various issues, such as
Netgear has a very small routing table and firmware that tends to reset the
router on a regular basis, early Linksys firmware was ...well, shite for the
most part but current firmware is pretty good. Dlink and Belkin were on the
bottom of the crap router list. Nothing I did made my server appear on the
list while using a Belkin router. Replaced the Belkin with a Netgear, poof,
server is on the list! I have to use a Actiontek modem because of my ISP,
but I put it in gateway mode and use the Linksys to handle the PPPOE and
that pretty much eliminates the Actiontek (which is a cheap piece of junk
modem/router) from causing problems. If you happen to have WRT54G laying
around, and if you can put your modem in gateway mode, you might try that.

----- Original Message -----
From: "Brian" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Tuesday, August 09, 2005 8:36 AM
Subject: Re: [hlds] Server isn't being shown on master list?


I'm beginning to think its x64.  Is anyone running a windows server with
x64?  I know there are seperate linux binaries for it.  I'm going to try
setting it up on one of my other computers, to hopefully eliminate
computer-specific stuff.

Brian wrote:
Connection to Steam servers successful.
   VAC beta secure mode is activated.
Adding master server 69.28.151.162:27011
Adding master server 207.173.177.11:27011

sv_enableoldqueries is set to 1

I just tried setting up a HL1 server, and it too didn't appear, which
makes me think its my router somehow.. not sure what it could be doing,
as the firewall is disabled, along with Stateful Packet Inspection.  In
addition, the default action of the router is to accept
incoming/outgoing packets, but it wouldn't know what to do with them
unless they fell into the forwarded ranges..

I've tried with and without VAC, so I think thats not the problem.

Could this be client side? The computer running the server is also
running the steam client (Yes, I know this could be a bad idea, however
I'm fairly confident it can handle it).  This is a x64 computer, and
there is a bug with the server list (It repeats servers over and over
again, and fails to get more then 10 or so servers).  I doubt it is a
clientside problem, as I've asked a couple of people if they can see my
server, and they say no.

I'm pretty much out of things that it could be :/



Sgt.Rock -=GOM=- wrote:

About sv_region...  My mistake..  ;)  Had them switched in my head  :p

In your console...  Do you get a respons like this?
Connection to Steam servers successful.
Adding master server 69.28.151.162:27011
Adding master server 207.173.177.11:27011
(ish)

And/or do you also get som challenge-errors?

If so, I have previously experienced that I had to put this in
server.cfg:
sv_enableoldqueries 1

(will allow old format of query from 3.party game-managers)
A steam-update 13. may this year changed the format for
server-queries...
Why it help on the missing entry in the master-list I don't know, but it
worked for me...

Regards,
Sgt.Rock

-----Oprindelig meddelelse-----
Fra: Brian [mailto:[EMAIL PROTECTED]
Sendt: 8. august 2005 19:09
Til: [email protected]
Emne: Re: SV: [hlds] Server isn't being shown on master list?


Adding the ip "x.x.x.x" line to my server.cfg didn't do anything.  If I
use a packet sniffer I can see the heartbeat commands being sent to the
servers, then a little while later I see the master servers request
stuff from my server, (rules, players, etc).. but they still don't add
it to the server list.

I think sv_region 0 is east coast,

eastcoast - sv_region 0
westcoast - sv_region 1
south america - sv_region 2
europe - sv_region 3
asia - sv_region 4
australia - sv_region 5
middle east - sv_region 6
africa - sv_region 7
world - sv_region 255

_______________________________________________
To unsubscribe, edit your list preferences, or view the list archives,
please visit:
http://list.valvesoftware.com/mailman/listinfo/hlds



_______________________________________________
To unsubscribe, edit your list preferences, or view the list archives,
please visit:
http://list.valvesoftware.com/mailman/listinfo/hlds


_______________________________________________
To unsubscribe, edit your list preferences, or view the list archives, please 
visit:
http://list.valvesoftware.com/mailman/listinfo/hlds

Reply via email to