We have had the same problem and now only source 2" core apaper rolls. The problem with 3" cores is that ususally the overall roll width is too big to fit on the rear feeder because there is not enough room between the back of the printer, and the edge of the roll due to the overall diameter of the 3" roll. Alan ----- Original Message ----- From: Margery Ellsworth To: [email protected] Sent: Sunday, October 05, 2008 9:03 AM Subject: [HPDesignJet_Printers] spindle adaptor available for 130?
I recently purchased a Designjet 130 printer, and just attempted to load a roll of paper onto the roll feed spindle thingy. It turns out that the core of the roll of paper I purchased is is 3" but the spindle ends are designed for a 2" core. I didn't realize there were different core sizes! Does anyone know whether spindle adaptors are available for the Designjet 130 printer? If they are, do you know where I could get one? Thanks!! Marge ------------------------------------------------------------------------------ No virus found in this incoming message. Checked by AVG - http://www.avg.com Version: 8.0.173 / Virus Database: 270.7.5/1708 - Release Date: 10/4/2008 11:35 AM
