Guten Tag, Groetnis! Your tip worked … I think I've used that process previously but I wasn't able to draw it out of the gray matter. ;)
Danke, Tschüss! On Thursday, June 26, 2014 1:59:26 AM UTC-4, Marius Loots wrote: > > Hallo, > > Thursday, June 26, 2014, 1:24:46 AM, you wrote: > > >> So I need to rotate the images before stitching? I tried it with the > >> stitched image and it distorted the image (making it snake about). The > >> image list shows the images (all shot vertically) sideways, BTW. I > found > > Terry> After alignment (in simple interface) or after optimisation (in > advanced > Terry> and expert interface), but before stitching, you should be able to > go > Terry> through whatever move/drag you want in the Preview to position the > image > Terry> as you would like. > Terry> Rotate using right mouse, move using the left mouse. > > I have a similar problem, on an irregular basis. If the panorama comes > out ok, but standing on its head, go to the Fast Preview Panorama > (expert interface) - Move/Drag Tab. There you will find Yaw, Pitch and > Roll. Enter 180 in the Roll box, click Apply. This will rotate the > whole image 180 degrees around the centre. > > The spit in the wind and turn three times counterclockwise step: The > 180 will stay in the box, but I usually enter 0 and click apply again. > Not sure if I leave the 180 how it will affect later stages, but > entering 0 has never caused problems. > > Groetnis > Marius > mailto:[email protected] <javascript:> > -- > add some chaos to your life and put the world in order > http://www.mapungubwe.co.za/ > http://www.chaos.co.za/ > skype: marius_loots > > Hierdie boodskap en aanhangsels is aan 'n vrywaringsklousule > onderhewig. Volledige besonderhede is by > www.it.up.ac.za/documentation/governance/disclaimer/ > beskikbaar. > > -- A list of frequently asked questions is available at: http://wiki.panotools.org/Hugin_FAQ --- You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/hugin-ptx/e5fae091-49a3-42e6-a7b3-77b4cc688279%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
