I am trying to figure out how to correct this issue. I am at z/OS V1.9.
IGD01008I ***********************************************************
IGD01008I ** A L L O C A T I O N F A I L E D ! ! **
IGD01008I ***********************************************************
IGD01008I ** DATA SET DOES NOT CONFORM TO PROD NAMING STANDARDS **
IGD01008I ** PLEASE CONTACT STORAGE MANAGEMENT FOR FURTHER DETAILS **
IGD01008I MESSAGES ISSUED BY STORCLAS ROUTINE HAVE EXCEEDED BUFFER AREA. NOT
ALL MESSAGES WERE WRITTEN.
According to the DFSMS manual I am only allowed 110 characters.
However, I have the following coded
----+----1----+----2----+----3----+----4----+----5----+----6----+----7---
WRITE '***********************************************************'
WRITE '** A L L O C A T I O N F A I L E D ! ! **'
WRITE '***********************************************************'
WRITE '** DATA SET DOES NOT CONFORM TO SYSTEM STANDARDS *******'
WRITE '** PLEASE CONTACT STORAGE MANAGEMENT FOR FURTHER DETAILS **'
WRITE '***********************************************************'
EXIT CODE(22)
END
Which is 299 characters (spaces counted).
Is there a way around this so I can produce more lines? Or do I have to reduce
my content until it is at or below 110 characters?
Lizette
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
