Just a guess, but --- The vary off/on sequence caused any kind of pending operation to be killed. There may also be some kind of reset that is done in the process. Finally, it caused the system to sense the device anew.
Regards, Richard Schuh > -----Original Message----- > From: The IBM z/VM Operating System > [mailto:[email protected]] On Behalf Of Martin, Terry > R. (CMS/CTR) (CTR) > Sent: Monday, July 20, 2009 10:29 AM > To: [email protected] > Subject: Re: Operator Console > > Thanks Marcy, I did what you suggested and it worked. Why do > you think it made the difference? I would have thought since > the device showed ENABLED that is was ready to go! > > Anyway thanks again! > > Thank You, > > Terry Martin > Lockheed Martin - Information Technology z/OS & z/VM Systems > - Performance and Tuning Cell - 443 632-4191 Work - 410 > 786-0386 [email protected] > > -----Original Message----- > From: The IBM z/VM Operating System > [mailto:[email protected]] On Behalf Of Marcy Cortes > Sent: Monday, July 20, 2009 12:13 PM > To: [email protected] > Subject: Re: Operator Console > > Try: > > disable 36b > vary off 36b > vary on 36b > enable 36b > xautolog operator on 36b > > > > Marcy > > "This message may contain confidential and/or privileged > information. If you are not the addressee or authorized to > receive this for the addressee, you must not use, copy, > disclose, or take any action based on this message or any > information herein. If you have received this message in > error, please advise the sender immediately by reply e-mail > and delete this message. Thank you for your cooperation." > > > > ________________________________ > > From: The IBM z/VM Operating System > [mailto:[email protected]] On Behalf Of Martin, Terry > R. (CMS/CTR) (CTR) > Sent: Sunday, July 19, 2009 3:50 PM > To: [email protected] > Subject: [IBMVM] Operator Console > > > > Hi > > > > I have defined a ICC console (36B) I added this address in > the System Config as the console and specify it on the LOAD > parameter at IPL time. > After the IPL operator was logged on to the ICC console > without a problem. I decided to logon to Operator HERE at my > desk so it took it away from 36B to me. Now I want to XAUTOLG > OPERATOR ON 36B. When I try I get the following error message: > > > > HCPAUT051E GRAF 036B is not enabled > > > > I display the device 36b and it says it is enabled: > > > > q 36b > > > > GRAF 036B ENABLED > > > > Is this happening because I defined it as a console and I > cannot XAUTOLOG Operator? Any help would be welcome. > > > > Thank You, > > > > Terry Martin > > Lockheed Martin - Information Technology > > z/OS & z/VM Systems - Performance and Tuning > > Cell - 443 632-4191 > > Work - 410 786-0386 > > [email protected] > > >
