Did you T into the existing manual bilge hose in the bilge?
-----Original Message----- From: harrybauersfeld <[email protected]> To: [email protected] Sent: Thu, Feb 4, 2010 12:50 pm Subject: [IC27A] Re: auto bilge pump I connected the existing tubing in the bilge to a Rule pump. The valves in the manual bilge pump are set up so the Rule pump can pump directly through it. The auto bilgfe pump works fine and I can still use the manual pump if I need to. --- In [email protected], WILLIAM WESENDER <wesen...@...> wrote: > > Is there room for two hose connections in the bilgeway to the transom area on > your boats? Vagabond has only one 3/4 inch tube for existing manal pump, and > looks like it fills the hole completely. > > > > > ________________________________ > From: "tedp...@..." <tedp...@...> > To: [email protected] > Sent: Wed, January 27, 2010 3:59:46 PM > Subject: Re: [IC27A] auto bilge pump > > Â > > Derek, I just looked at this pump on line is this mounted in your bilge or > just sets in there? > > Ted Pinelli > > -----Original Message----- > From: Derek Atkin <atkin...@yahoo. com> > To: ic...@yahoogroups. com > Sent: Wed, Jan 27, 2010 4:52 pm > Subject: Re: [IC27A] auto bilge pump > > I put a Rule 750 in the bottom of the bilge and ran its own line to the > transom. I drilled an installed a stainless thru hull to handle the output. > It was a very easy job, very inexpensive and I like the idea of fresh > redundant plumbing. > > Derek.- > 79 C27 > #4297 > > ____________ _________ _________ __ > From: "tedp...@aol. com" <tedp...@aol. com> > To: ic...@yahoogroups. com > Sent: Wed, January 27, 2010 4:34:31 PM > Subject: [IC27A] auto bilge pump > > I am considering installing an auto bilge pump on our 82. I would like to > leave the existing manual pump in place and operable. Any suggestions on pump > make model, install and maximum uses of existing plumbing? > > Ted Pinelli > Andiamo, Keuka Lake NY > > [Non-text portions of this message have been removed] > > [Non-text portions of this message have been removed] > > [Non-text portions of this message have been removed] > > > > > [Non-text portions of this message have been removed] > [Non-text portions of this message have been removed]
