To do a really clean job, you can mask both parts, leaving a little reveal (1/16”-1/8”). Get the cleanest, tightest fillet you can with your finger, then gently wipe with a solvent soaked rag. Let it set, then peel off the tape. Note that white 4200 does yellow a little over time.
Keith Sneddon #4760, “Are We There Yet?” From: [email protected] [mailto:[email protected]] On Behalf Of Sonshingle Sent: Tuesday, September 07, 2010 8:52 PM To: [email protected] Subject: RE: [IC27A] (no subject) Keith, How do you make that fillet of 4200 at the base of the handrail look good? If I did it it wouldn't look good! How do you make a smooth finish there? Dick Schmidt Greenville, NC --- On Tue, 9/7/10, Sneddon, Keith - ES <[email protected]> wrote: From: Sneddon, Keith - ES <[email protected]> Subject: RE: [IC27A] (no subject) To: "[email protected]" <[email protected]> Date: Tuesday, September 7, 2010, 10:56 AM I would use white 4200, not clear silicone. I would apply a thin coat to the mating surface, install the handrail with the sealant wet, let it dry, then add a small fillet bead at the base. I am sort of in the middle of the same project (only it is all the external teak, plus a bunch from the cabin). I used Bristol Finish. My current plan, on all the pieces that require plugs, is to: 1) Scuff the parts with 220 to remove the sheen on all the surfaces that are accessible after installation. 2) Install the parts with a thin coat of white 4200 on the mating surface. 3) Install the plugs with waterproof carpenters glue, and sand to flush. 4) Mask the boat around the teak. 5) Put on more coats of Bristol, starting with a small area around the plug, and increasing the wetted area until the last coat or two covers the whole piece. I anticipate using 4 more coats. 6) Let that dry, then remove the masking. 7) Put a small fillet of white 4200 at the interface between the teak and the deck. Yes, it’s a lot of work. I will never, ever do this again. Keith Sneddon #4760, “Are We There Yet?” From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Tuesday, September 07, 2010 10:42 AM To: [email protected] Subject: [IC27A] (no subject) Hello all, I have removed the teak hand rails to refinish then. When re installing, I was going to use clear silicone to re bed them. What is the best technique to use? I could apply the silicone and replace the rail when the silicone is still wet or is it best to let a ring of silicone dry on the hull around the screw hole and then place the rail after it completely dry. Any suggestions would be appreciated. Ted Pinelli ________________________________ This e-mail and any files transmitted with it may be proprietary and are intended solely for the use of the individual or entity to whom they are addressed. If you have received this e-mail in error please notify the sender. Please note that any views or opinions presented in this e-mail are solely those of the author and do not necessarily represent those of ITT Corporation. The recipient should check this e-mail and any attachments for the presence of viruses. ITT accepts no liability for any damage caused by any virus transmitted by this e-mail.
