Win 2000 will route without the registry entry if you configure RRAS.
Also, the internal NIC should not have a gateway listed.
192.168.x.x is a routable IP address, as listed in the RFC's as reserved
for private use only. Once RRAS is configured, or the registry entry
made, then the internal address will be routed to the Internet,
establishing NAT. If you use the method of registry entry, make sure the
routing table has all the routes in it, as you will most likely have to
manually add a persistent static route.
John Tolmachoff, Network Engineer
211 E. Imperial Hwy., Suite 106
Fullerton, CA� 92835
714-578-7999, ext. 104
[EMAIL PROTECTED]
www.reliancesoft.com
�
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]] On Behalf Of Sanford
Whiteman
Sent: Wednesday, September 19, 2001 11:21 PM
To: Tim
Cc: [EMAIL PROTECTED]
Subject: Re: [IMail Forum] Routing with 2000 Server and Dual NICs
Tim,
You have two problems:
1) Win2K doesn't route between NICs unless you set:
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Tcpip\Parameters\IP
EnableRouter
to 1 and reboot.
2) You are not apparently using NAT, so your non-routable private
subnet (192.168.0.0) couldn't possibly receive packets back from the
'Net anyway (by definition).
Write back directly if you're still stuck.
Regds,
Sandy
Please visit http://www.ipswitch.com/support/mailing-lists.html
to be removed from this list.
An Archive of this list is available at:
http://www.mail-archive.com/imail_forum%40list.ipswitch.com/
Please visit http://www.ipswitch.com/support/mailing-lists.html
to be removed from this list.
An Archive of this list is available at:
http://www.mail-archive.com/imail_forum%40list.ipswitch.com/
