I understand this issue has been hashed again and again and again hundreds of times... 
but after
searching the archives, I am still stumped.

Situation:
I have a Sun Ultra 5 (Solaris 9) as a dialup router/firewall/server/kitchen sink/etc. 
at home, which
maintains a dialup modem connection to my ISP.  We'll say its Internet address is 
64.64.64.64 (dev sppp0) at the moment.
I also have an internal LAN, 192.168.0.0/24.  My Sun box's IP on this LAN is 
192.168.0.1 (dev hme0), and it is the default
route for all internal LAN boxes (it also runs Sun's DHCP server).

I have a laptop on this LAN.  My laptop has RedHat Linux 9 with
PPTP software installed, and that works great (when it's given a real Internet 
address).
It is the ONLY client in my LAN which needs to do ANYTHING with PPTP or GRE.  It needs 
to connect to the
corporate VPN server (which is on a public Internet IP), we'll call it 12.12.12.12.
My laptop's IP is 192.168.0.45.

I understand I can set up a rdr using IPNat so GRE packets coming from 12.12.12.12 to 
my dialup modem can be
redirected to my laptop's IP (192.168.0.45) using a rule like:
rdr sppp0 0.0.0.0/0 port 0 -> 192.168.0.45 port 0 gre

I am not sure if this works, because the following scenario exists when I try to make 
a PPTP connection:

My laptop sends packets to the corporate VPN server (12.12.12.12) with protocol=47 
(GRE), however
Source IP=192.168.0.45, Dest IP=12.12.12.12.  That's fine, except my Sun box continues 
to send that packet
out the modem as Source=192.168.0.45, Dest=12.12.12.12 !
It does not rewrite the Source IP of the outbound GRE packet.  Are there any rules I 
should add to enable this?

Note that I determined this by use of Solaris's "snoop" program.  I noticed that TCP 
NAT'ed packets for the port 1723
connection appeared in "snoop" as bearing the destination/source IP of the Sun box's 
dialup modem IP, rather than the
laptop's internal IP.  The IP packets bearing protocol "47" all said source IP of 
192.168.0.45, so I assume that means
it sent the packet out the modem as such.



Also for the record, I have basic TCP/UDP NAT'ing for all boxes in my internal LAN, 
using the following IPNat rule:
map sppp0 192.168.0.0/24 -> 0.0.0.0/32 portmap tcp/udp 20000:30000


Thank you very much!

Reply via email to