I upgraded my MythTV system to ivtv 0.4.1 and kernel 2.6.14.4 and now I get no sound on my PVR-350 from either live tv or recorded programs.
Sound system is working - Xine playing DVDs and MythMusic are working fine. I've reset the settings in alsamixer/amixer. Internal cabling has not changed from my previously working ivtv 0.4.0 setup. The correct msp3400 is being loaded -- I compiled ivtv from source and executed the recommended mv commands. Any suggestions? My init messages are below. Thanks, Kirk ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.4.1 (tagged release) loading ivtv: Linux version: 2.6.14.4-wcpvr01 SMP gcc-3.4 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected WinTV PVR 350 card (cx23415 based) ACPI: PCI Interrupt 0000:01:02.0[A] -> GSI 17 (level, low) -> IRQ 185 ivtv0: Unreasonably low latency timer, setting to 64 (was 32) tveeprom: The eeprom says no radio is present, but the tuner type 68 tveeprom: indicates otherwise. I will assume that radio is present. tveeprom: ivtv version tveeprom: Hauppauge: model = 48132, rev = K268, serial# = 2985761 tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio processor = MSP4448 (type = 1b) tveeprom: decoder processor = SAA7115 (type = 13) ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] saa7115 0-0021: ivtv driver saa7115 0-0021: saa7115 found @ 0x42 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=saa7115, addr=21] saa7127 0-0044: ivtv driver saa7127 0-0044: saa7129 found @ 0x88 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=saa7127, addr=44] msp3400 0-0040: ivtv driver msp3400 0-0040: chip=MSP4448G-A2 +nicam +simple +simpler +radio mode=simpler msp3400 0-0040: msp34xxg daemon started ivtv0: i2c attach to card #0 ok [client=MSP4448G-A2, addr=40] tda9887 0-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02050032 ivtv0: Decoder revision: 0x02020023 ivtv0: Allocate DMA encoder MPEG stream: 256 x 32768 buffers (8192KB total) ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv0: Create encoder radio stream ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total) ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total) ivtv0: Create decoder VOUT stream ivtv0: Allocate DMA decoder YUV stream: 48 x 43200 buffers (2048KB total) ivtv0: loaded v4l-cx2341x-init-mpeg.bin firmware (155648 bytes) tuner: type set to 47 (LG NTSC (TAPE series)) by ivtv i2c driver #0 tuner: switching to v4l2 tuner: tv freq set to 67.25 tuner: tv 0x07 0x10 0x8e 0x01 ivtv0: Initialized WinTV PVR 350, card #0 ivtv: ==================== END INIT IVTV ==================== _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
