I installed MythDora 2.1 (auto install). I've got one capture card, a WinTV PVR-150. All I see in MythTV is snow. Same thing if I try itvt-tune. I noticed that I've got a "tuner model is unknown" message, and I assume that's where the problem lies.
I'm a novice, so it is very likely that I've done something stupid (but the MythTV auto installer is supposed to be relatively idiot proof). The sticker on the tuner on the card says NTSC/NTCS-J 26132 REV FB02. In MythTV, the Composite video works just fine, the problem is just with the tuner. I'm hooked up to analog cable. I tried the card in a Windows box, and it worked just fine with the WinTV2000 application. May 22 22:02:43 localhost kernel: ivtv: ==================== START INIT IVTV ==================== May 22 22:02:43 localhost kernel: ivtv: version 0.4.3 (tagged release) loading May 22 22:02:43 localhost kernel: ivtv: Linux version: 2.6.15-1.1831_FC4 686 REGPARM 4KSTACKS gcc-4.0 May 22 22:02:44 localhost kernel: ivtv: In case of problems please include the debug info between May 22 22:02:44 localhost kernel: ivtv: the START INIT IVTV and END INIT IVTV lines, along with May 22 22:02:44 localhost kernel: ivtv: any module options, when mailing the ivtv-users mailinglist. May 22 22:02:44 localhost kernel: ivtv0: Autodetected WinTV PVR 150 card (cx23416 based) May 22 22:02:44 localhost kernel: ACPI: PCI Interrupt Link [LNK1] enabled at IRQ 3 May 22 22:02:44 localhost kernel: ACPI: PCI Interrupt 0000:05:06.0[A] -> Link [LNK1] -> GSI 3 (level, low) -> IRQ 3 May 22 22:02:44 localhost kernel: ivtv0: Unreasonably low latency timer, setting to 64 (was 32) May 22 22:02:44 localhost kernel: ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] May 22 22:02:44 localhost kernel: tveeprom 2-0050: Hauppauge model 26132, rev F0B2, serial# 9400357 May 22 22:02:44 localhost kernel: tveeprom 2-0050: tuner model is unknown (idx 112, type 0) May 22 22:02:44 localhost kernel: tveeprom 2-0050: TV standards NTSC(M) (eeprom 0x08) May 22 22:02:44 localhost kernel: tveeprom 2-0050: audio processor is CX25841 (idx 35) May 22 22:02:44 localhost kernel: tveeprom 2-0050: decoder processor is CX25841 (idx 28) May 22 22:02:44 localhost kernel: tveeprom 2-0050: has no radio, has IR remote May 22 22:02:44 localhost kernel: tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #0) May 22 22:02:44 localhost kernel: ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] May 22 22:02:44 localhost kernel: cx25840 2-0044: cx25841-23 found @ 0x88 (ivtv i2c driver #0) May 22 22:02:44 localhost kernel: cx25840 2-0044: loaded v4l-cx25840.fw firmware (13353 bytes) May 22 22:02:44 localhost kernel: ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44] May 22 22:02:44 localhost kernel: wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #0) May 22 22:02:44 localhost kernel: ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b] May 22 22:02:44 localhost kernel: ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) May 22 22:02:44 localhost kernel: ivtv0: Encoder revision: 0x02050032 May 22 22:02:44 localhost kernel: ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) May 22 22:02:44 localhost kernel: ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) May 22 22:02:44 localhost kernel: ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) May 22 22:02:44 localhost kernel: ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) May 22 22:02:44 localhost kernel: tuner 2-0061: type set to 0 (Temic PAL (4002 FH5)) May 22 22:02:44 localhost kernel: ivtv0: Initialized WinTV PVR 150, card #0 May 22 22:02:44 localhost kernel: ivtv: ==================== END INIT IVTV ==================== Any ideas? Thanks in advance. Regards, Geir _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
