On Thursday 01 June 2006 18:30, Marcel Janssen wrote: > I set the debug option, but I think the info below doesn't provide much. > The firmware failed to load again for some reason. I'll try to get more > info later.
Got some more info attached. I hope it helps. I don't understand the 400Mhz setting being later reported as 0.4Mhz, which is out of range. Perhaps this gives a clue to what is going wrong. regards, Marcel ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.6.2 (development snapshot compiled on Mon May 8 07:35:43 2006) loading ivtv: Linux version: 2.6.16-1.2111_FC5 686 REGPARM 4KSTACKS gcc-4.1 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected Hauppauge WinTV PVR-350 card (cx23415 based) ACPI: PCI Interrupt 0000:00:0d.0[A] -> GSI 16 (level, low) -> IRQ 18 tveeprom 4-0050: Hauppauge model 48134, rev J347, serial# 7110286 tveeprom 4-0050: tuner model is LG TP18PSB01D (idx 47, type 28) tveeprom 4-0050: TV standards PAL(B/G) (eeprom 0x04) tveeprom 4-0050: audio processor is MSP4418 (idx 25) tveeprom 4-0050: decoder processor is SAA7115 (idx 19) tveeprom 4-0050: has radio, has IR remote tuner: tuner_debug is deprecated and will be removed in 2.6.17. tuner: use the debug option instead. tuner 4-0061: Setting mode_mask to 0x0e tuner 4-0061: chip found @ 0xc2 (ivtv i2c driver #0) tuner 4-0061: tuner 0x61: Tuner type absent saa7115 4-0021: saa7115 found @ 0x42 (ivtv i2c driver #0) saa7127 4-0044: saa7127 found @ 0x88 (ivtv i2c driver #0) msp3400 4-0040: MSP4418G-A2 found @ 0x80 (ivtv i2c driver #0) msp3400 4-0040: MSP4418G-A2 supports nicam and radio, mode is autodetect and autoselect ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02050032 ivtv0: Decoder revision: 0x02020023 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv0: Create encoder radio stream ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total) ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total) ivtv0: Create decoder VOUT stream ivtv0: Allocate DMA decoder YUV stream: 20 x 51840 buffers (1024KB total) ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes) tuner 4-0061: Calling set_type_addr for type=28, addr=0xff, mode=0x04 tuner 4-0061: type set to 28 (LG PAL_BG+FM (TPI8PSB01D)) tuner 4-0061: ivtv i2c driver #0 tuner I2C addr 0xc2 with type 28 used for 0x0e tuner 4-0061: Cmd VIDIOC_S_STD accepted for analog TV tuner 4-0061: switching to v4l2 tuner 4-0061: tv freq set to 400.00 tuner 4-0061: tv: range 1 tuner 4-0061: Freq= 400.00 MHz, V_IF=38.93 MHz, Offset=0.00 MHz, div=7023 tuner 4-0061: tv 0x1b 0x6f 0x8e 0x90 tuner 4-0061: Cmd VIDIOC_S_FREQUENCY accepted for radio tuner 4-0061: radio freq set to 0.40 tuner 4-0061: radio freq (0.40) out of range (65-108) tuner 4-0061: radio 0x05 0xea 0x88 0xa5 ivtv0: Initialized Hauppauge WinTV PVR-350, card #0 ivtv: ==================== END INIT IVTV ==================== ivtv0: ================= START STATUS CARD #0 ================= tveeprom 4-0050: Hauppauge model 48134, rev J347, serial# 7110286 tveeprom 4-0050: tuner model is LG TP18PSB01D (idx 47, type 28) tveeprom 4-0050: TV standards PAL(B/G) (eeprom 0x04) tveeprom 4-0050: audio processor is MSP4418 (idx 25) tveeprom 4-0050: decoder processor is SAA7115 (idx 19) tveeprom 4-0050: has radio, has IR remote tuner 4-0061: Tuner mode: radio tuner 4-0061: Frequency: 0.40 MHz tuner 4-0061: Standard: 0x000000ff tuner 4-0061: Signal strength: 16384 tuner 4-0061: Stereo: no saa7115 4-0021: Audio frequency: 48000 Hz saa7115 4-0021: Input: Composite 4 saa7115 4-0021: Video signal: bad saa7115 4-0021: Frequency: 50 Hz saa7115 4-0021: Detected format: BW/No color saa7127 4-0044: Standard: 50 Hz saa7127 4-0044: Input: normal saa7127 4-0044: Output: S-Video + Composite saa7127 4-0044: WSS: disabled saa7127 4-0044: VPS: disabled saa7127 4-0044: CC: disabled msp3400 4-0040: MSP4418G-A2 rev1 = 0x0117 rev2 = 0x1242 msp3400 4-0040: Audio: volume 58880 msp3400 4-0040: Mode: AM (for carrier detect) msp3400 4-0040: Standard: could not detect sound standard (mono) msp3400 4-0040: ACB: 0x0c00 ivtv0: ================== END STATUS CARD #0 ================== _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
