On Tuesday 12 December 2006 18:50, Sander Sweers wrote:
> pdp wrote:
> > I have problems with the activation of my Hauppauge 350 TV card.
> > I've followed the guide at edgy IVTV guide
> > (https://help.ubuntu.com/community/Install_IVTV_Edgy)
> > <https://help.ubuntu.com/community/Install_IVTV_Edgy>
> > As far as I can judge the activation of the IVTV driver was
> > succesfull. Also the setting of the frequency went ok:
> >
> > ivtv-tune -t europe-west -c E12 ==> /dev/video0: 224.250 MHz
> >
> > (I'm living in Belgium. Our television distributor is Telenet.
> > 224.250 Mhz is the frequency for the VTM channel)
> >
> > But when I issue: mplayer /dev/video0 I get only a screen with
> > noise
> >
> > For the moment I'm a bit disappointed because the reason I bought
> > the 350 was because it was one of the cards that was best
> > supported under Linux. Therefore I've the feeling that may be some
> > detail (ivtvctl setting ?) must be changed but I have no clue what
> > I should try
> >
> > I hope someone can help me solve this problem.
> > Thank you for taking time to look into this problem.
> >
> > Best regards,
> >
> > Peter
> >
> > Information regarding my setup:
> >
> > - the card works under Windows XP so the hardware is ok
> > - I'm using Ubuntu Edge as my main OS
> > - output of uname -a: Linux test 2.6.17-10-generic #2 SMP Fri Oct
> > 13 18:45:35 UTC 2006 i686 GNU/Linux
> > - output of dmesg:
> >
> > [17179586.036000] ivtv: ==================== START INIT IVTV
> > ====================
> > [17179586.036000] ivtv: version 0.7.0 (tagged release) loading
> > [17179586.036000] ivtv: Linux version: 2.6.17-10-generic SMP
> > mod_unload 586 REGPARM gcc-4.1
> > [17179586.036000] ivtv: In case of problems please include the
> > debug info between
> > [17179586.036000] ivtv: the START INIT IVTV and END INIT IVTV
> > lines, along with
> > [17179586.036000] ivtv: any module options, when mailing the
> > ivtv-users mailinglist.
> > [17179586.068000] bcm43xx driver
> > [17179586.424000] NET: Registered protocol family 17
> > [17179586.600000] ivtv0: Autodetected Hauppauge WinTV PVR-350 card
> > (cx23415 based)
> > [17179586.600000] ACPI: PCI Interrupt 0000:01:01.0[A] -> GSI 21
> > (level, low) -> IRQ 66
> > [17179586.644000] tveeprom 0-0050: Hauppauge model 48139, rev K2B7,
> > serial# 8889298
> > [17179586.644000] tveeprom 0-0050: tuner model is Philips FM1216ME
> > MK5 (idx 117, type 4)
> > [17179586.644000] tveeprom 0-0050: TV standards PAL(B/G) PAL(I)
> > SECAM(L/L') PAL(D/D1/K) (eeprom 0x74)
> > [17179586.644000] tveeprom 0-0050: audio processor is MSP4418 (idx
> > 25) [17179586.644000] tveeprom 0-0050: decoder processor is SAA7115
> > (idx 19) [17179586.644000] tveeprom 0-0050: has radio, has IR
> > remote [17179586.708000] eth1: register 'asix' at
> > usb-0000:00:1d.7-3, ASIX AX88772 USB 2.0 Ethernet,
> > 00:30:4f:43:83:a7
> > [17179586.708000] usbcore: registered new driver asix
> > [17179586.716000] tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver
> > #0) [17179586.908000] tda9887 0-0043: chip found @ 0x86 (ivtv i2c
> > driver #0) [17179586.960000] saa7115 0-0021: saa7115 found @ 0x42
> > (ivtv i2c driver #0) [17179587.156000] saa7127 0-0044: saa7129
> > found @ 0x88 (ivtv i2c driver #0) [17179587.176000] msp3400 0-0040:
> > MSP4418G-B3 found @ 0x80 (ivtv i2c driver #0)
> > [17179587.176000] msp3400 0-0040: MSP4418G-B3 supports nicam and
> > radio, mode is autodetect and autoselect
> > [17179587.828000] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144
> > bytes) [17179587.840000] ivtv0: loaded v4l-cx2341x-dec.fw firmware
> > (262144 bytes) [17179588.072000] ivtv0: Encoder revision:
> > 0x02050032
> > [17179588.080000] ivtv0: Decoder revision: 0x02020023
> > [17179588.080000] ivtv0: Allocate DMA encoder MPEG stream: 128 x
> > 32768 buffers (4096KB total)
> > [17179588.080000] ivtv0: Allocate DMA encoder YUV stream: 161 x
> > 12960 buffers (2048KB total)
> > [17179588.080000] ivtv0: Allocate DMA encoder VBI stream: 80 x
> > 26208 buffers (2048KB total)
> > [17179588.080000] ivtv0: Allocate DMA encoder PCM audio stream: 455
> > x 4608 buffers (2048KB total)
> > [17179588.080000] ivtv0: Create encoder radio stream
> > [17179588.080000] ivtv0: Allocate DMA decoder MPEG stream: 16 x
> > 65536 buffers (1024KB total)
> > [17179588.080000] ivtv0: Allocate DMA decoder VBI stream: 512 x
> > 2048 buffers (1024KB total)
> > [17179588.080000] ivtv0: Create decoder VOUT stream
> > [17179588.080000] ivtv0: Allocate DMA decoder YUV stream: 20 x
> > 51840 buffers (1024KB total)
> > [17179588.160000] ivtv0: loaded v4l-cx2341x-init.mpg firmware
> > (155648 bytes) [17179588.292000] tuner 0-0061: tuner type not set
> > [17179588.368000] tuner 0-0061: tuner type not set
>
> The above 2 lines is your problem. You seem to have a unknown tuner
> type for the kernel. You can try and set it 38 in /etc/modprobe.conf
> by adding:
>
> options ivtv tuner=38
>
> Now reload the ivtv module which should make the tv tuner work but
> the radio will probably not.
>
> Hans, a potential tester with a FM1216ME MK5 tuner in his PVR-350 :-)
No longer needed: it's already been confirmed that tuner 38 is OK for
this. Autodetection for this tuner was added in kernel 2.6.19.
Regards,
Hans
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
