I'd rather start with this ENC chip since I know for sure that I'll have working hardware. All PIC's with internal Ethernet are SMD, I don't have much experience with SMD. If there is a pre-build ethernet board with Ethernet in PIC, I may try it. Anyways, I'm currently buying some parts to practice SMD.
Why would SPI be a problem? I'll use a good 5v supply, and a 3.3v voltage regulator, that should give enough power right? I think I may be finished with SLIP now. I don't see much point in using it any further. I guess TCP/IP requires 8kb buffer but SLIP buffer size is only 1006 (according to RFC 1005). It was great to use at first, but now I think I'll try to get ICMP to work over Ethernet and go on from there. Matt. -- You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/jallib?hl=en.
