thanks a lot. where can I do that? before exporting the dsn file? inside the router?
2009/5/21 kajdas <[email protected]> > > > You should specify spacing required between holes/pads and traces and > router will take care of the rest. > M. > > > On Thu, May 21, 2009 at 2:33 PM , Julien Bayle wrote: > > > but I have a last question... > > > > I put holes in my pcb and I would like to avoid traces too much near > > from those holes... > > A friend adviced me to use zones around these holes before the > > autorouting... I did that, but probably, I have to do a special thing > > in freerouting.net... > > > > any ideas ?? > >
