could you help me with that? I looked for that ... I didn't find anything in kicad.. only the drc test... but I don't find the rules... and how I could change and tweak them :-(
Julien 2009/5/22 kajdas <[email protected]> > > > Every router will have some kind of settings/preferences menu where you > specify that. > I route by hand so in Kicad, I specify it in DRC Control dialog (PCB Design > Rules Check) > M. > > > On Thu, May 21, 2009 at 3:27 PM , Julien Bayle wrote: > > > thanks a lot. > where can I do that? > before exporting the dsn file? inside the router? > > > 2009/5/21 kajdas < *[email protected]* <[email protected]>> > > > <[email protected]> > You should specify spacing required between holes/pads and traces and > router will take care of the rest. > M. <[email protected]> > > > On Thu, May 21, 2009 at 2:33 PM , Julien Bayle wrote: > > > but I have a last question... > > > > I put holes in my pcb and I would like to avoid traces too much near > > from those holes... > > A friend adviced me to use zones around these holes before the > > autorouting. .. I did that, but probably, I have to do a special thing > > in freerouting. net... > > > > any ideas ?? > >
