I found another way (but it is a tip...) I create zone around holes I fill them and I uncheck the Parameter>route>ignore conduction aeras it works.. But I guess your advice is THE solution, not my tip...
--- In [email protected], Julien Bayle <julien.ba...@...> wrote: > > thanks a lot. > where can I do that? > before exporting the dsn file? inside the router? > > > 2009/5/21 kajdas <kaj...@...> > > > > > > > You should specify spacing required between holes/pads and traces and > > router will take care of the rest. > > M. > > > > > > On Thu, May 21, 2009 at 2:33 PM , Julien Bayle wrote: > > > > > but I have a last question... > > > > > > I put holes in my pcb and I would like to avoid traces too much near > > > from those holes... > > > A friend adviced me to use zones around these holes before the > > > autorouting... I did that, but probably, I have to do a special thing > > > in freerouting.net... > > > > > > any ideas ?? > > > > >
