Every router will have some kind of settings/preferences menu where you
specify that.
I route by hand so in Kicad, I specify it in DRC Control dialog (PCB
Design Rules Check)
M.
On Thu, May 21, 2009 at 3:27 PM , Julien Bayle wrote:
thanks a lot.
where can I do that?
before exporting the dsn file? inside the router?
2009/5/21 kajdas < [email protected] <mailto:[email protected]> >
<mailto:[email protected]>
You should specify spacing required between holes/pads and traces and
router will take care of the rest.
M. <mailto:[email protected]>
On Thu, May 21, 2009 at 2:33 PM , Julien Bayle wrote:
but I have a last question...
I put holes in my pcb and I would like to avoid traces too much near
from those holes... A friend adviced me to use zones around these
holes before the autorouting. .. I did that, but probably, I have to
do a special thing in freerouting. net...
any ideas ??
