Hi, Thanks for your reply. Yeah. Those errType came from settings of clearance. Like a threshold value check. But I think that this clearance check can be relevantly according to different rules purposes. A different errTypes are in a result by different clearance settings. Hope Kicad wishlist have such this. Thanks, -Adam
--- In [email protected], Andy Eskelson <andyya...@...> wrote: > > > The errors tell you what the problems are, basically they are clearance > issues. This can happen during layout if your bends in the tracks cut > across a pad and "clip" the clearance area. The same thing applies to the > zones, it's just too close to something. > > The co-ords in the error message will identify the location on the board > where the problems are. > > The first thing to do is fix the errors. How you do that will depend on > the layout, usually I find that it just needs a slight tweak of the track > position. Other times a reduction in track width might do the job, and > so on. > > > > > Andy > > > On Mon, 04 Jan 2010 08:22:33 -0000 > "carouse9" <cl.adamw...@...> wrote: > > > > > > > Hi > > > > --- In [email protected], "fuzzyviv" <fuzzyviv@> wrote: > > > > > > > > > > > > But be sure to check your gerbers and drill files in either gerbv on > > > linux, or any gerber viewer in windows before sending. > > > Specially drill files. > > > I used the following settings for drill file dialog and it works- > > > > > > suppress leading zeros > > > precision 2:4 > > > origin - absolute > > > minimal header yes > > > mirror y axis - no > > > > > Hi, > > > > We are doing a project [1]. After Pcb Design Rules Check in PCBnew, I got > > two kinds of err, type 19[2] and type 23[3]. Do you think that those err > > are serious? From them, I am assuming they are detected because of > > judgement from kicad default settings. > > > > Also I followed and made settings as [4] and tried to create drill file[5], > > then I used a popular windows CAM gerber viewer to check it but I got err > > [6], do you think this is not caused by any potential errs we didn't know? > > Thanks > > Adam > > > > [1] http://projects.qi-hardware.com/index.php/p/board-qi-avt2/ > > [2] > > http://downloads.qi-hardware.com/hardware/qi_avt2/RC2/report/layout_note/20100104/drc_control_errtype19.jpg > > [3] > > http://downloads.qi-hardware.com/hardware/qi_avt2/RC2/report/layout_note/20100104/drc_control_errtype23.jpg > > [4] > > http://downloads.qi-hardware.com/hardware/qi_avt2/RC2/report/layout_note/20100104/drill_files_generation.jpg > > [5] > > http://downloads.qi-hardware.com/hardware/qi_avt2/RC2/report/layout_note/20100104/Qi_AVT2.drl > > [6] > > http://downloads.qi-hardware.com/hardware/qi_avt2/RC2/report/layout_note/20100104/DRLREAD.ERR > > > > > > > > ------------------------------------ > > > > Please read the Kicad FAQ in the group files section before posting your > > question. > > Please post your bug reports here. They will be picked up by the creator of > > Kicad. > > Please visit http://www.kicadlib.org for details of how to contribute your > > symbols/modules to the kicad library. > > For building Kicad from source and other development questions visit the > > kicad-devel group at http://groups.yahoo.com/group/kicad-develYahoo! Groups > > Links > > > > > > >
