The roller pillow I've got isn't very fancy and the method used to hold the roller in place is a smaller wooden wedge. You just insert it between the roller and the side of the hole it sits in. It holds well enough so I'd think having even a really small one on each side would hold a roller in place without difficulty.
Darlene Mulholland -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: March 30, 2004 7:08 AM To: [EMAIL PROTECTED] Subject: [lace] Holding the roller When I had a very basic roller pillow with no satisfactory anchor to stabilise the roller I found the most effective way to hold it was by using a piece of tape or ribbon over the top of each end of the roller with the front ends pinned into the pillow near the roller (they are mainly needed to keep the roller down into the box, but also so you don't have to put "weight-bearing pins" into the roller), and have longer ends at the back pinned low down on the pillow with the pin at angled so the point is higher than the head. It is the pins at the back that do the work; they are holding both the constant weight of the bobbins and the extra pull when you are working . I then put a pin through the tape at the top of the roller. To turn the roller this was the only pin that needed to be moved. As I said before, it is the back edge of the roller that needs to be held firmly but I found that if I tried to hold the roller in place with a pin or tape just from the back of the roller to the pillow, it damaged the roller because you are pulling hard against it. I think you said that your pillow has a hole but the roller is now too wide to fit in it. If you over-fill the hole with something soft like wadding and pin a cloth loosely over the top then you will be able to seat the bottom curve of the roller into the stuffing, so it doesn't move around much. If I am mistaken about the hole, the same principle should work but I would make two firm "sausages" and pin them to the pillow first, to make a groove for the roller to sit into so it is more secure. If you are using the whole width of the roller to work on (which I assume you are otherwise you wouldn't need such a wide one <VBG>) then you could have 3 or 4 tapes and remove them as needed so they are not across the bit of pillow you are using. The pins will probably be far enough apart to allow the tape to go between them. I hope some of these ideas are of help to you. Jacquie - To unsubscribe send email to [EMAIL PROTECTED] containing the line: unsubscribe lace [EMAIL PROTECTED] For help, write to [EMAIL PROTECTED] --- Incoming mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.644 / Virus Database: 412 - Release Date: 26/03/2004 --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.644 / Virus Database: 412 - Release Date: 26/03/2004 - To unsubscribe send email to [EMAIL PROTECTED] containing the line: unsubscribe lace [EMAIL PROTECTED] For help, write to [EMAIL PROTECTED]
