> >>>From: Ann-Marie L�rdal [mailto:[EMAIL PROTECTED] > How did you attach it to the pillow? I have been suggested to hold it down > with velcro (I was thinking of using drain pipe holders, dressed in fabric, > and put them at an angle in the hole for the original roller :-)) but > velcro sounds better. <<< >
Hello everybody, for holding the roller I suggested Ann-Marie to use velcro tape, and in my case it worked perfekt. Another possibility which I have used succesfully is the following: I made a roller to use with my 3x3block pillow. I took out three blocks and placed the roller in the block-frame.To avoid rolling forward-backward in the frame i placed two half-blocks on the edge,behind roller and between the roller and the frame, as far out in the ends as possible, to allow as much space for pricking and lace as possible. Then I fastened two tapes to the block-frame and pinned them to the roller on "the front side" of the roller, i.e. direction towards the lacemaker.Allso this solution worked very well for me. Best wishes from a sunny, but stil frosty Denmark, where the garden is calling. Aage - To unsubscribe send email to [EMAIL PROTECTED] containing the line: unsubscribe lace [EMAIL PROTECTED] For help, write to [EMAIL PROTECTED]
