Jeff Newmiller wrote: > > On Mon, 11 Feb 2002, guitarlynn wrote: > > and forget about pin 3 that runs to > > the IDE cable altogether.
Yes you can forget about pin3 if they ever make that jumper. > Using chassis ground as signal ground is not recommended, as the two may > differ significantly if an electrical short occurs or if you start > disconnecting parts out of sequence. > > Remember, current flows in a loop... keep the loop small (area wise) and > use the appropriate ground references. This was pointed out to me, also. The appropriate power for the high signal and low signal are found on the LD017, and the switch solution should take noise into consideration. > I haven't seen any schematics including an LD017... but the SST58SDnnn > made by SSTI uses pin 10 for WP#. Ok. I put the LD017 schematic on my ftp site. This is the one that Mike Noyes offered to email anyone who was interested in the gory details. The original is the MS-Word doc file, and the pdf was made by me. The pdf has what you are looking for, but it's a bit truncated. Matthew _______________________________________________ Leaf-devel mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-devel
