Hello, I managed to get this router and want to get lede on it. The hardware is this
Lantiq VRX288 500Mhz 2 NANYA NT5TU128M8HE-AC 256MB RAM ZENTEL A501GA31ATS 8G 128MB NAND FLASH. Wireless 2.4Ghz BCM43222KFBG Wireless 5Ghz BCM4360KMLG VDSL/ADSL2+ XWAY VRX208 5 port GB Ethernet I already found serial port pins and got the console log. The log is almost silent. I managed to get to the brnboot shell short cutting pins in the flash but cant do a flash dump. ERASE Flash --------------------------------------- Area Address Length --------------------------------------- [0] Boot 0x00000000 1024K [1] Image 0 0x00100000 10240K [2] Image 1 0x00B00000 10240K [3] Configuration 0x01500000 2048K [4] Boot Params 0x01700000 2048K [5] Nvram 0x01900000 1024K [6] Cert 0x01A00000 32768K [7] EmergencyValue 0x03A00000 6144K [8] Configuration2 0x04000000 2048K [9] All area 0x00000000 67584K If I try to read from above address the router gets locked. I can read from certain area like memory or 0xBC000000 or 0xBE000000 but others locks the router. The boot ask for a password and continues booting. The emergency boot kernel is openwrt 10.3 I found out that short cutting R201 I get CFG 07 instead of CFG 06 so maybe UART Mode is R201 + R203 but not sure. Not quite sure to try it... I can load to memory using xmodem transfer and run but all I tried get locked without any output. What I want is first dump the current content of the flash. Any ideas? Thanks in advance JRios _______________________________________________ Lede-dev mailing list Lede-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/lede-dev