I am glad to hear that you found your problem, and were able to fix it. GOOD DEAL ! ;-)
C.A.G. ----- Original Message ----- From: "Don W." <dwi...@hotmail.com> To: "Legacy Ornamental Mills" <legacy-ornamental-mills@googlegroups.com> Sent: Sunday, February 19, 2017 6:03:15 PM Subject: Re: Accurate setup Curtis and Bill, Thanks for the input. All of these turned out to be correct. Found that there was a .050 inch difference between the distance from the top to the rail to the bottom of the bracket that rides on the rail (the bracket that has the felt taped to it). Well if you guys hadn't told me the finish should be smooth, I was going to be satisfied with the shimming fix. Long story short, took the whole router carriage off and found that whoever put the machine together had not made the sure to fully bottom out the tabs into the extruded aluminum rail. Problem solved. I'm very pleased with the result. Don W. Curtis 11:18 AM (5 hours ago) Other recipients: Don Here is an idea for you, make a bracket to hold a drill motor behind your Legacy, and then using a screw and a jam nut, lock the motor and the drill onto your machine. then spin the wood with the drill and turn the crank handle slowly along Don Here is an idea for you, make a bracket to hold a drill motor behind your Legacy, and then using a screw and a jam nut, lock the motor and the drill onto your machine. then spin the wood with the drill and turn the crank handle slowly along your spindle. Im not sure where your ridges are coming form, but when I use my motor drive ... my spindles look like glass compared to your photos. good luck. talk to you more latter. C.A.G. aussiman 11:21 AM (5 hours ago) Other recipients: Don have you got both cross slide rails the correct side up the aluminium rails are not the same both sides one side has a small groove running down the middle which is facing up. on mine anyway. That amount of groove is way too much it should be Don have you got both cross slide rails the correct side up the aluminium rails are not the same both sides one side has a small groove running down the middle which is facing up. on mine anyway. That amount of groove is way too much it should be smoother even after you have packed it. also no washers between delrin top hats and carrier tray Bill -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com . To post to this group, send email to legacy-ornamental-mills@googlegroups.com . Visit this group at https://groups.google.com/group/legacy-ornamental-mills . For more options, visit https://groups.google.com/d/optout . -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at https://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.