Philo wrote:
>> Any suggestions are welcome.
>> Further i have difficulty aligning parts correctly. The built in
>> snapping seems to be helpful, but very often parts just
>> end up at the wrong position. Then i turn snapping off and move parts
>> around which then end up in better positions
>> but still have to be moved over the Modify panel. All in all a
>> sometimes frustrating process.
>> Especially when small alignment errors add up to a total of like 5mm.
>> An even bigger problem is when rotation is involved.
>
> Did you have a look to these tutorials about grids and angle grids
> (http://trac.gerf.org/leocad/wiki/LeoCadDoc)?
>
I did now and that helped a lot. Didn't know you could switch between
grids :\
Maybe i'll even go through the parts of the model again to correct
previous alignment errors.
> Cheers,
>
> Philo
_______________________________________________
Leocad mailing list
[email protected]
https://list.gerf.org/listinfo/leocad
