I was asked if I "can you verify you are set t o100/Full on your side"
for my Linux LPAR; I have looked at the output from the hardware scan
and the sys log messages but I did not see anything that would show that
information / at least what I could understand from the data. The
output from "ifstatus eth0" is here:
dvelnux1:/local # ifstatus eth0
eth0
eth0 configuration: qeth-bus-ccw-0.0.3200
eth0 is up
4: eth0: <BROADCAST,MULTICAST,UP> mtu 1492 qdisc pfifo_fast qlen 1000
link/ether 00:02:55:89:0a:21 brd ff:ff:ff:ff:ff:ff
inet 10.128.24.233/24 brd 10.128.24.255 scope global eth0
inet6 fe80::2:5500:2189:a21/64 scope link
valid_lft forever preferred_lft forever
eth0 IP address: 10.128.24.233/24
Configured routes for interface eth0:
default 10.128.24.1 - -
169.254.0.0 - 255.255.0.0 eth0
Active routes for interface eth0:
10.128.24.0/24 proto kernel scope link src 10.128.24.233
169.254.0.0/16 scope link
default via 10.128.24.1
1 of 2 configured routes for interface eth0 up
But I don't see anything that tell me the speed or full / half duplex.
Did I miss something?
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
