On Jun 18, 2007, at 3:43 PM, Clark, Douglas wrote:
I was asked if I "can you verify you are set t o100/Full on your side" for my Linux LPAR; I have looked at the output from the hardware scan and the sys log messages but I did not see anything that would show that information / at least what I could understand from the data. The output from "ifstatus eth0" is here:
Well, on Intel systems you'd generally do "ethtool eth0". That didn't work so well on my Layer 3 Guest LAN, but maybe that's not surprising: [EMAIL PROTECTED]:~# ethtool eth0 Settings for eth0: No data available Adam ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
