I've installed SLES10 SP2 in LPAR mode and can't recall running into any difficulties. Best I remember, was a pretty clean and straight-forward install.
-----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of David Stuart Sent: Wednesday, October 01, 2008 12:35 PM To: [email protected] Subject: SuSE 10 SP 2 - LPAR Install - Gotcha's? Morning all, <set newbie on> I am preparing to do a new 'bare-metal' (i.e. LPAR) install of Suse 10 SP 2. No, no z/VM, no IFL. (Maybe if I'm good, Santa will ...) I installed SLES 9 SP 3 at one time, with considerable assistance from a Novell engineer (Thanks Mike!), so I have done this once before. But now it's time for SLES 10. I am looking for any pointers, gotcha's I need to watch for, hints/tips, etc. I did search the archives, but it seems that very few people are doing what I am trying to do. </set newbie on> TIA, Dave Dave Stuart Prin. Info. Systems Support Analyst County of Ventura, CA 805-662-6731 [EMAIL PROTECTED] ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
