On Thu, Jan 27, 2000 at 03:04:54PM +0100, Mitja Bezget wrote:
> I set up two soundblasters (modems) on two computers. When I wanted
> to test it with a cross-wired audio cable (no radio RTX) it just
> didnt work.
> When I run a packet thru sm0 I can measure it with an oscilloscope.
> It looks pretty nice. But the computer on the other side just does not
> respond! I have tried all modulations..
> I wanted to fine tune the i/o levels with smmixer/smdiag but smdiag
> didnt work for me. The screen was always blank with a straight horizontal
> line (one pixel wide). I tried all command line options but at the end I
> gave up and tuned the output level with an oscilloscope. I tried several
> settings for input level but it still didnt work.
> I also did NOT specify PTT... Is it necessary in my case?
> I'm using 2.0.38, AWE64, AWE32, P/133, P2/233, axtools-2.1.42 ...
You do not need to specify PTT in this case, the sound modem doesn't
mind if you don't have PTT.
Perhaps the mixer settings on the receiving sound card are wrong?
Either the levels are wrong or the line in is not selected for recording.
Something like "smmixer s=line" (on SB16) should fix that. That would
be why smdiag doesn't show anything.
Hamish
--
Hamish Moffatt Mobile: +61 412 011 176 [EMAIL PROTECTED]
Rising Software Australia Pty. Ltd. http://www.risingsoftware.com/
Phone: +61 3 9894 4788 Fax: +61 3 9894 3362 USA: 1 888 667 7839
