On Mon, 28 Aug 2000, George Easaw wrote:
Most likely you have set up a mode which is not supported by the monitor.
for starters you can make XF86Setup to the fiddling for you. While booting
int linux give
linux 3
at the lilo prompt. Login as root and run XF86Setup. Its anice, user
friendly utility, where you can setup your mouse, card, monitor and view
mode options
hope it helps
sreangsu
> hello,
> i am anewbie in linux..
> i have RH 5.2 installed on the dept m/c in mech engg dept.
> the display was giving low resolution and so i tried to fiddle with the
> /etc/X11/XF86Config file..
>
> i changed the value of
>
> depth 24
> modes 800x600 1024x768
> valueport 0 0
> Virtual1024 768
>
> after rebooting, find the monitor is flashing.... can i get some advice
> on what to do..
> thanks, george..
>
>
> ----------------------------------------------
> Find out more about this and other Linux India
> mailing lists at http://lists.linux-india.org/
>
----------------------------------------------
The mailing list archives are available at
http://lists.linux-india.org/cgi-bin/wilma/LIH
