Hello,
L.V.Gandhi saw fit to inform me that:
>we have purchased new zenith PC cel 566 having 810 chip and shared
>memory and Samtron 55v monitor. I installed RH6.2 from PCQ CD. As said
>in mag I avoided X configuration and after rebooting I did setup and
>Xconfiguration. Though intel chip and as SVGA detected, I followed all
>said in exocore/linux, X was not staring. I installed gart and XFcom and
>di as said in the guide, now also it doesn't work. I get error unknown
>chip. Anybody having similar config? If so kindly send XF86Config file.
Have you upgraded your kernel to 2.2.16 ? I have got a PC with PIII 810
board. But it is an assembled PC. Red Hat 6.2 out of box does not support X
on my machine. But after upgrading the kernel to 2.2.16 XFsetup
autodetects. No problems. Works fine.
The XF86Config file is in office. Will send it across to you tomorrow. But
if you try the above stuff then there is no need of my XFConfig file I
suppose.
Warm Regards
--
Rajesh Fowkar
/**********************************************************************************\
* WebSite:http://rajesh.computers.webjump.com Email : [EMAIL PROTECTED]
* Address:KURTARKAR NAGARI,BLDG-C,T4,3RD FLOOR,SHANTINAGAR,PONDA-GOA.(INDIA)
*
* "The expert at anything was once a beginner." -Hayes
/**********************************************************************************\
----------------------------------------------
The mailing list archives are available at
http://lists.linux-india.org/cgi-bin/wilma/LIH
